15%
of turnover to R&D
Research & development
About 15% of annual turnover is reinvested in the R&D centre, from functional testing to automatic mould development.
Technology
Air out.
Everything else stays.
Three components decide whether a vacuum bag survives a season or a decade: the valve, the film and the seal.
Inside the bag
Engineered at the level you cannot see.
- Efficient Air Valve A one-way membrane that opens under vacuum and closes under pressure. Invented and patented nationwide in 2013, miniaturised in 2019 for travel formats. No cap to lose, no gasket to re-seat.
- Seven-layer PA + PE film Nylon carries the strength, polyethylene carries the seal. Co-extruded in one pass so the barrier cannot delaminate — the reason a SPACUUM bag still holds vacuum after a humid summer.
- Double-rail zip Two independent tracks with a colour-matched slider. If one rail is compromised, the bag still seals. The slider is sized so that a full sweep is enough for a correct close.
- Fool-proof welding Seam fixtures developed by our own technical department hold burst strength constant across a production run, so the tenth bag behaves exactly like the first.
R&D
15% of turnover goes back into development.
100+
own patents
OEM & ODM
From valve to bag corner, from print to colour-matched slider — built to your most demanding specification.
300
pcs minimum
Small orders
Orders from a few hundred pieces are accepted, so new partners can start their vacuum-bag business without risk.
6
control dimensions
Quality control
Six control dimensions, fool-proofing fixtures and lean production since 2015 — "make it right once".
Standards
Certified where it matters.
ISO 9001:2015
Quality management system, GB/T19001-2016
BSCI
Business Social Compliance Initiative audited
REACH
EU chemical compliance for PA + PE materials
CE
Applicable product directives for EU markets